User Tools

Site Tools


This is an old revision of the document!

Playing Alti+ Maps

Most of playing games on an alti+server is the same as any other server. Many changes are relatively obvious, and can be seen at map start. However, some may not be. Below are a number of commands you can use to play successfully.

/list map

This command will display the settings changes for the current map. If gravity is different, the spawnMode settings, plane restrictions, etc. you can see all of these settings with this command.

/sz start

Many maps on an alti+server update your spawn point based on zones, or crossing specific power ups. Sometimes, you need to get back to the initial start. If this is required, use /sz start to update your spawn zone to be the standard map starting point.

/list doors

If a map has doors, you can use this command to list the doors, their keys, and see which keys are yet to be acquired to open the door.

/list zones

If a map has zones, you can use this command to list the zones, their keys, and see which keys are yet to be acquired to open the door.

/list portals

A portal is a powerup which, when found, removes you from the map and sets your next spawn to be somewhere else (aka teleport). To see which portals exist on a map, and where they teleport to, you can run this command and all available portals for your team will be displayed.


This command allows you to change planes without having to die. After changing planes, you will spawn exactly where you left off. This command is meant to help individuals play coop maps which require more than one plane type to finish. Normally, this command only works when few players are on the server. To find out if this command is enabled on a server, you can refer to the output of /list map.

playing.1466559760.txt.gz · Last modified: 2016/06/22 01:42 by biell